Specialist Automotive Sockets 10-Piece
10S, 6pt., for Toyota idle wheel centre screw.
6S, 6pt., for Nissan & Renault clutch.
8S, 6pt., for Nissan cylinder head & balance shaft.
12S, 6pt., for Nissan cylinder head.
8TS, 3pt., for Nissan balance shaft.
10 mm, 5pt., for brake systems.
12 mm, 5pt., for Nissan fuel pump.
14 mm, 5pt., for GM & Smart Car.
19 mm, 5pt., for Peugeot, Renault & Citroen parking brake.
20 mm, 10pt., for Honda Civic lower control arm.
Length: 38mm.
Spreader Socket Set for Spring Strut Clamp, 5 x 7mm and 5.5 x 8.2mm
Subframe Locating Pins For VAG Group
Primary Used on a variety of VA Model Vehicles Including Volkswagen Scirocco 09-. EOS (06), Golf (09), Golf Plus (05), Jetta (04-06), Polo (02), Fox (06), Passat (06), Passat CL (09) and Audi A3 (04), TT (07) and A4 (01).
On some vehicles in the Volkswagen Audi Group the sub-frame needs to be removed to service the suspension bushes, when removing the clutch, changing the engine, servicing the wheels, steering, stabilizer bar or control arms.
These pins are screwed into the sub-frame and used to guide it back into place once the task is complete. Care should be taken to bolt back diagonally and to the manufacturer's recommended torque.
Two sizes are available: The first an M12 can be fitted to Volkswagen Scirocco (09), EOS (06), Golf (09), Golf Plus (05), Jetta (4-06) Polo (02), Fox (06), Passat (06), Passat CL (09), Audi A3 (04), TT (07) and A4 (01) - OEM T10096 (Sub-frame Locating Pins - Volkswagen and Audi Group (Part No 4722)).
The second size an M14 is primarily used for the new Volkswagen Crafter - OEM T10227 (Part No 4840).
Thin Walled Lambda Sensor Socket 22mm – Ford
Twist Sockets; 3-Piece 1/2”dr Thin Wall Flip Sockets
The lug nuts become distorted due to improper leverage using the factory supplied tire iron. Removing over-torqued lug nuts during extreme cold/heat also distorts lug nut cap to non standard sizes.
Use these dedicated sockets every time you loosen the Locking Wheel nut and remove damaged/distorted lug nuts with their versatile size range ideal for worn and distorted nuts.
Dual flip 1/2'' drive impact socket design.
Product classed as Consumable.
Supplied in EPA Foam Tray.